Sebo G-SERIES Owner's Manual download pdf (Page 9)

MAINTENANCE

Figure 9

Figure 10

Figure 11

Figure 12

Always unplug vacuum from outlet before dismantling any part of the machine!

Dust Bag

Part #5093 AM

Micro-Hygiene

Filter

Part #5036 AM

Exhaust Filter

Part #2846

Brush Roller G1

Part #5010 AM

Brush Roller G2

Part #2838 AM

Changing the Dust Bag - Figure 9

o change the dust bag, pull the cover release flap forward

(#5 on page 6) and lift the cover (7) from the dust bag

housing. The cover release flap must remain in a for-

ard “pulled-out” position to change dust bags and lock

them into place. Squeeze the clamps on both sides of the

dust bag sealing plate (29), slide the plate from the hold-

er (30) and push the cap on to seal the bag. Slide the seal-

ing plate (29) of a new bag into the holder and push it in

firmly. Re-insert cover into dust bag housing, push it for-

ward, then lock it in place by pushing down the cover

release flap. You may find it convenient to store the bag

cap inside the dust bag housing below the dust bag.

Changing the Micro-Hygiene Filter -

Figure 10

The micro-hygiene filter (31) needs to be changed when it

becomes extremely dirty or clogged with dust, or after

approximately 20 dust bags have been used. To change

the micro-hygiene filter, pull the cover release flap (#5 on

page 6) forward and lift the cover (7) from the dust bag

housing. Then, slide the filter out at the bottom. To

replace, lift the safety lever (32) and slide the new filter in

using the tracks as guides.

Changing the Exhaust Filter - Figure 11

After 20 bags have been used, change the exhaust filter

(33). Remove the dust bag housing (6) from the power

head by pressing the housing release button (8). To

remove the exhaust filter, push the catch (34) and remove

the filter cover (35) and exhaust filter. Insert the new fil-

ter, replace the filter cover then insert the dust bag hous-

ing back into the power head.

Changing the Brush Roller - Figure 12

To change the brush roller (37), push the button (36),

remove the side plate (38), turn the brush clockwise a

quarter of a turn, and pull the old brush roller out. Slide

the new brush roller into the brush housing and turn it

until it locks into position. While slightly pushing the but-

ton (36), press the side plate (38) back into the locked

position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Sebo G-SERIES Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Vacuum cleaners Sebo G-SERIES