Sebo Automatic X4 Owner's Manual download pdf (Page 9)

Using the Attachment Tube, Hose & Attachments -

Figures 4, 5 & 6

The attachment tube (16) is useful for vacuuming corners and hard-to-reach

areas. The handle grip (1) should be in the upright, locked position (as shown

n figure 4). Grip the attachment tube handle (11), pull it up and away from the

machine and stretch out the hose (12) until it locks to the back of the tube (this

locking action will prevent the hose from retracting back into the attachment

tube while it is in use). Various attachments may be inserted onto the end of the

tube. After use, remove attachment and re-insert the attachment tube into the

back of the machine. Be sure that the attachment tube handle (11) is inserted

ver the protruding tab (see #22, page 6). If the attachment tube handle is

properly seated over the protruding tab, the hose will automatically retract and

you may resume vacuuming. There is no need to turn off the vacuum while

switching from upright vacuuming to using the attachment tube or hose.

To use the hose without the attachment tube (as shown in figure 5), pull the hose

out of the attachment tube while the tube is still attached to the machine and

securely seated over the protruding tab (22). Insert an attachment tool, if desired,

onto the end of the flexible hose. You may also release the hose while the attach-

ment tube is disengaged from the machine by pressing the release button at the

base of the handle (11).

While using attachment tools, if the power head brush roller is not able to dis-

engage from the floor surface, the stationary-use warning light will flash. You

may keep the brush roller off the carpet by placing the handle (1) in its upright

locked position and lowering the handle with one hand to raise the brush roller

off of the floor. Operate attachment accessories with the other hand. Or, with

the handle in the upright locked position, the machine may be tipped backward

so that it rests against furniture or the floor on the back side of the bag hous-

ing (6), and the power head is locked in a perpendicular position to the floor.

Ensure that no children or pets can come into contact with the spinning brush

roller.

To vacuum walls, under beds, or higher-reach areas, etc., the SEBO AUTOMATIC

X can be fitted with an additional straight tube (45) and the wall and floor brush

(41). The machine will then perform as a canister vacuum (as shown in figure

6).

The Adjustment Wheel - Figures 8 & 9

On hard floors (figure 8), the adjustment wheel (40), moves upward into the

machine so that the brush lowers and becomes flush with the floor.

On carpeted floors (figure 9), the adjustment wheel (40) moves downward out of the

machine so that the brush rises. The adjustment wheel moves up and down auto-

matically to adjust the brush to the correct setting. This provides aggressive brush

action, while maintaining optimal air flow.

Hard Floor

Carpeted Floor

The Display Panel - Figure 7

Green light (a): Brush is lowering

Green light (b): Brush is rising

Red light (c): Flashing and motor off - brush jammed – clear jam

Red light (c): Flashing and motor on (when machine is in upright,

locked position) – Take care, brush in contact with carpet

Red light (c): Continuous – change brush roller

Red light (d): Continuous – change bag or clear clog

Red light (d): Flashing – motor switched off due to full bag or clog

For more information on the display panel, see pages 4 and 5.

Figure 4

Figure 5

Figure 6

Figure 7

Figure 9

Figure 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Sebo Automatic X4 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Vacuum cleaners Sebo Automatic X4